CI-1500 Series Bosch ev1 1500cc  Fuel Injectors with plug and play injector connectors
 
Clean Injection CI1500 Series injectors are Bosch Motorsport base injectors. Designed to suit setups requiring 60mm length with 11mm inlet orings. Includes a set of 4pcs EV1 Female to Nippon Denso Male Plug and Play Fuel Injector Connector adapters. PLEASE VIEW VEHICLE COMPATIBILITY GUIDE BELOW. Injectors are high impedance so no resistor box/injector drivers are necessary.  
 
 
Clean Injection CI1500 series injectors have full stainless steel internationals making it compatible with all known fuels including e85. The injectors retains a consistent linear flow from 2bar to 5bar fuel pressure. Very tuner friendly with fuel trimming down to 1ms.  Every set of Injectors that leaves Clean Injection goes through extensive testing on industry leading ASNU Classic test equipment. Every set is flow tested statically, dynamically, and packed in balanced sets within 1 percent. Injectors will come with flow sheet with full data specs including injector latency/dead time data to make tuning breeze. 
 
 
INJECTOR FEATURES:
Flow Matched Sets within ≤ 1% Static and Dynamic flow rates
Full Injector Latency Data Provided
Tunable to factory Rock solid Idle
Excellent Fuel Atomization
Direct Plug and Play Fit
Fast Response time
Consistent performance all the way to 7 BAR
Unlimited Mile Warranty
Stainless Steel Internals 
Compatible with all known race fuels including E85
 
 
Injector Specs:
Static Flow Rate (gasoline) 1500cc @ 43.5PSI 
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: Wide 30 degree mist (single orifice)
Electrical Connector: USCAR ev1- nippon denso male
Fitted with Viton upper and lower o-rings.
Length: 60mm 
Fuel Rail Oring Size: 11mm
Intake Seal: 15mm grommet seal